Adjusting timeouts in the Snapt One Load Balancer and Web Accelerator
When adjusting the timeout of connections in the virtual Load Balancer you must go to Balancer -> Configuration -> Default...
- Home
- Balancer
Balancer
-
-
Video / Screencast: Sticky Sessions in the Snapt One Load Balancer
We take a look at how Snapt One virtual Load Balancer does session affinity and some of your options. We... -
When will the Load Balancer not compress?
The Snapt One Load Balancer is able to compress certain request/content, not only does this save on bandwidth cost, but... -
Redirect if all nodes are down
There are certain circumstances under which your network may experience an extremely high load, even with the Balancer and Accelerator,... -
Balancer Source Restriction
Layer 4 Method: Step 1. Follow the steps below to setup your required ACL Head to Balancer -> ACL Management Then... -
How to route hosts to different backends
This guide well explain how to use the Balancer to send different hostnames (host headers) to different backends (servers). This... -
Correcting the duplicate Balancer process issue
Certain clients with specific configurations and versions have had an issue where duplicate Balancer/HAProxy processes are causing a split-brain type... -
Snapt One Load Balancer with TPROXY
The Snapt One software Load Balancer is able to operate under a TPROXY setup for transparency. This is not advised... -
How to drain a server
When you need to perform important or emergency maintenance on one of your servers but don’t want to disrupt existing... -
Error: verify is enabled by default but no CA file specified
SSL Server Verification is enabled by default. If you receive an error such as “Error: verify is enabled by default...