1. Home
  2. Balancer
  3. Exchange 2016 load balancing

Exchange 2016 load balancing

Snapt provides an automatic wizard for configuration load balancers for Microsoft Exchange 2016. To use the wizard navigate to the Balancer -> Create a load balancer menu item and then choose Exchange.


Creating Your Group

Once you select the Exchange Wizard you will be taken to a page where you must complete the following tasks:

  1. Specify an IP address to listen on.
  2. Set a name for your group (for reporting, alerts, etc).
  3. Add the Exchange servers IP addresses.

This can be seen below. It is important to specify an IP and not use Any as the port 25 bind can clash with our local email daemon.


Microsoft Exchange 2016 Requirements

Exchange 2016 comes ready to go for load balancing and DOES NOT need any port or registry changes with Snapt. After the wizard you can start the load balancer and it will be up and running immediately.

Get a trial!

If you are a new Snapt user, feel free to get a trial of the product!


If you have any trouble getting the load balancer up and running please log a ticket or email support@snapt.net.

Updated on September 28, 2018

Was this article helpful?

Related Articles